XADO MOTO Small Engine Treatment

$19.99      

XADO MOTO USES:

• Dirt Bikes
  
• Scooters
  
• Outboard Motors
  
• Chainsaws
  
• Trimmers
  
• Mowers
  
  

  XADO - MOTO
  Procedure for treating a 2-cycle engine with pre-mixed fuel and oil system

  Step 1
  

  1. Squeeze out the contents of one sachet into the full fuel tank (it is recommended first to dissolve the contents of the packet in the oil at temperature 104-122F (40-50°C) or in the gas at temperature above 68F (20° C).
     
  2. Run as normal.
     
     NOTE: For small engines, use 1 packet for each gallon of premix and use as normal.
     

  Step 2
  Repeat Step 1 when you refill the tank (the gas with gel should be fully consumed).
  

  Step 3
  Repeat Step 2

  NOTE: For small engines, (chainsaws, trimmers, etc.) use 1 packet of MOTO to treat one gallon of pre-mix. Run the equipment as normal.
  
  Treatment procedure for 4 cycle engines with separated fuel and oil.
  

  Step 1
  

  1. Warm up the engine to running temperature.
     
  2. Squeeze out the contents of one packet into the filler of the engine oil tank.
     
  3. Start the engine and let it idle for no less than 2 minutes.
     
  4. Run as normal.
     

  Step 2
  Repeat Step 1 after 90-150 miles (150-200 km) run of the motorcycle or 4 hours of idle work of the engine (equivalent of 120-150 miles run).
  

  Step 3
  Repeat 2.